EEPROM manager

The EEPROM manager is a rather technical program to reset the entire EEPROM to the RFzero default values, setup of some of the station data, disable the I2C user bus, dump the EEPROM data, dump the EEPROM in Intel hex format or erase the EEPROM.

The EEPROM manager is used through the USB port and there is no display used.

Menus

The EEPROM manager has a main menu and a number of sub menus. To navigate the menus enter the relevant letter or enter the MMI command. Menu letters can be entered in both lower and upper case. Commands must, like always, be entered in lower case, just like the MMI commands in the other programs.

To return to the main menu enter “Z”.

Main menu

  • A: all below and check EEPROM
  • B: reset hardware
  • C: reset GPS
  • D: reset common
  • E: reset beacon
  • F: reset WSPR transmitter
  • G: reset QO-100
  • H: reset GPSDO
  • I: reset frequency counter
  • J: reset multi LO
  • K: reset signal generator
  • S: station data menu
  • T: technical menu

Station menu

  • rd cfg
    to list name, call and locator
  • wr name NAME
    to set the station NAME, max 20 characters
  • wr call CALL
    to set the CALL, max 15 characters
  • wr loc LOCATOR
    to set the LOCATOR, max eight characters
  • Z: back to main menu

Technical menu

  • A: disable I2C user bus
  • B: dump EEPROM to USB
  • C: dump EEPROM in Intel hex format to USB
  • D: erase EEPROM
  • rd byte ADDR
    to read a byte value
  • rd int ADDR
    to read an unsigned integer value
  • wr byte ADDR VALUE
    to write a byte value
  • wr int ADDR VALUE
    to write an unsigned integer value

where ADDR is the EEPROM address in decimal and VALUE may be in decimal or hex (0x…).

  • Z: back to main menu